Inspector Configuration

After clicking on the “Create” button, if the new user is set to belong to the Inspector group, you will be presented with the Inspector Setup Wizard, which allows for the configuring of what inspections/section this user can do.

The first step in the Inspector Setup Wizard is to select the Sections that this inspector should be allowed to perform inspections in.

Once the desired sections have been selected, you can continue to the next step by clicking on “Next”.

This screen allows you to select if the inspector should be able to be assigned to all inspections in the selected sections, or if the inspector should be limited to only certain inspections.

Selecting “Yes” will create the user and that user will be available to schedule any inspection in any of the selected sections.

Selecting “No” will take you to the next step, which allows for the selecting of which inspections can be done by this user in each of the selected sections.

From here, you can select the specific inspection, per section, that this inspector can be assigned to. Any inspection not selected, will prevent this inspectors name from being available in the schedule inspection screen for that type of inspection.